Month: September 2024 (Page 1 of 2)

In Concord, MA the house can be no taller than 35′ from the ground (without getting a special permit), where the ground is measured as the average of the ground level of two lowest points of the basement/foundation.

The engineering firm has measured the elevation of the ground level to be 124′. The previous massing was based on a ground level of 127′, three feet higher, and the previous massing used all of the available height. This means that the proposed roof peak is now 3′ too tall. Sigh.

The architect and Daphne are discussing how to deal with this. We can reduce the slope of the roof, which would lower the peak, but that causes some problems with the design of the whole roof, and may also lead to a propensity of ice dams forming (although Daphne says ice dams is not the issue). We can just push the attic down such that rooms in the second floor would have sloped sides near the walls. This is probably not a problem if we only drop down a foot or two, but once the height of the side wall gets lower than 6′ we start to have problems with doorways, furniture, etc. Discussions are ongoing. Watch this space.

The architect has added in a roof overhang on all sides of the house. Among other things, this keeps rain from going into the windows (assuming the rain is not falling sideways). But when we add in the roof overhang, we get into trouble with setbacks, and that pesky non-conforming garage.

There are two places where a problem has crept in. The first is the roof overhang over the front door. The town says that the roof overhang can not be closer than the 40′ setback from the road without a special permit. So we will redesign the front of the house a little from the last set of drawings to have a flat facade with only a small front porch. This removes 4 feet from one of the upstairs bedrooms, but that is not really an issue for us.

The second problem is that the required 10′ of separation between the proposed shed attached to the garage and the house is measured from the edge of the roof overhangs (not the wall of the house). To ensure enough spacing, we had to shift the whole house by 4″ (thankfully easier to do now than after the house is built). This small repositioning actually allowed us to slightly increase the size of the deck, which is a good thing.

Along with the design of the massing of the house, shown in the previous post, we also have a first cut at the layout of the second floor. The second floor is smaller than the first floor, because the living space does not extend over the master bedroom or the gaming room.

This is the first real design, based on earlier discussions. There may be some further iterations. A key feature are the big windows in the family room which will have a better view of the river than anywhere else in the house. We will likely have some comfy chairs near the window, where you can sit and read or watch the boats go by.

As currently designed, the first floor is approximately 2500 sq ft and the second floor is approximately 1600 sq ft. There are three bedrooms, two and a half baths and eight rooms in total (which is important because that’s the room count limit based on the existing septic system).

Our architect has an initial design for the massing of the house, which she presented to us today in a Zoom call. Right now it is very white and has no windows. I assume those features will be downloadable content we can buy later.

Anyway, here is the rough proposed design for the house. The first rendering shows the front of the house, looking down from a drone hovering over the driveway.

The second rendering shows the back side of the house. The stairs are leading down from the deck. The upper-left part of the house is the porch off of the gaming room. That little section of the roof that sticks up is the second floor bathroom.

Our architect has been great and has moved the house design forward quite quickly, but this week we were reminded that we are not our architect’s only clients. So after a burst of activity (see Designing a House from the Inside Out), things have slowed down a little.

Right now the bottleneck is working on the “massing”. This was a new term for me, so I looked it up: Massing is a term in architecture which refers to the perception of the general shape and form as well as size of a building. And our architect is struggling a little with the massing, especially as it pertains to the roof over the master bedroom suite. Daphne should find out more on Friday, when she has a Zoom call with the architect.

Part of the problem is that we have imposed a lot of requirements, especially for that part of the house. High ceilings, no living space over the master bedroom suite, and a roof design that will not tend towards problems with ice dams. Nothing is ever easy, and we have not even gotten to the hard parts yet.